FRAME/BODY PANELS/EXHAUST SYSTEM
SNAP FIT CLIP
Separate the parts by pulling the snap fit clip
Make sure that the
straight out of the hole, being careful not to tilt the
insertion of the clip
insertion of the clip.
is not tilted when
removing or install-
Check the snap fit clip for damage and replace if
ing the snap fit clip.
necessary.
If tilted upon
Install the parts by inserting the snap fit clip straight
removal or installa-
into the hole, being careful not to tilt the insertion of
tion, damage to the
the clip.
insertion or/and the
hole may occur.
MAINTENANCE LID
Unlock the seat lock with the ignition key and open
the seat.
Remove the two special screws.
Release the side tabs from the body cover and the
front tabs from the floor panel to remove the main-
tenance lid.
Installation is in the reverse order of removal.
SEAT
Unlock the seat lock with the ignition key and open
the seat.
Remove the two nuts while supporting the seat to
remove it.
Installation is in the reverse order of removal.
3-4
INSERTION OF THE
SNAP FIT CLIP
SNAP FIT CLIP
TABS
MAINTENANCE LID
NUTS
SCREWS
SEAT