Honda SH300 2006 Manual page 208

ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL
Remove the following:
– maintenance lid (page 3-4)
– luggage box (page 3-5)
– grab rail (page 3-5)
– body cover (page 3-6)
– rear fender A (page 3-7)
– floor side cover (page 3-8)
– under cover (page 3-9)
– exhaust system (page 3-15)
– throttle cable (page 6-53)
– fuel injector quick connect fitting (page 6-44)
– air cleaner (page 6-52)
Drain the engine oil (page 4-11).
Drain the coolant (page 7-7).
Remove the two bolts and brake hose protector.
Remove the two caliper mounting bolts and rear
Support the brake
brake caliper.
caliper so that it
does not hang from
Remove the two bolts and brake hose clamps.
the brake hose.
Do not twist the
brake hose.
Disconnect the ignition coil wire connectors.
Release the wire band and ignition coil wire.
Disconnect the alternator 3P connector and CKP
sensor 2P (red) connector.
Release the alternator and CKP sensor wires from
the clamp.
8-4
CALIPER
MOUNTING BOLTS
BOLTS/CLAMPS
CONNECTORS
3P CONNECTOR
PROTECTOR
BOLTS
WIRE BAND
2P CONNECTOR
CLAMP