Honda SH300 2006 Manual page 255

LEFT CRANKCASE COVER
REMOVAL
Remove the belt case air cleaner housing (page 4-
16).
Remove the following:
– bolt (10 mm head) and wire clamp (from the left
crankcase cover)
– eleven bolts (8 mm head)
– left crankcase cover
– two dowel pins
– rubber seal
DRIVESHAFT BEARING INSPECTION
Turn the bearing with your finger.
The bearing/collar should turn smoothly and qui-
etly.
Also check that the bearing outer race fits tightly in
the left crankcase cover.
DRIVESHAFT BEARING REPLACE-
MENT
Remove the driveshaft bearing from the left crank-
case cover using the special tools.
TOOLS:
Bearing remover set, 20 mm 07936-3710600
Bearing remover handle
Remover weight
DRIVE AND DRIVEN PULLEYS/CLUTCH
BOLT/CLAMP
07936-3710100
07741-0010201
LEFT CRANKCASE COVER
RUBBER SEAL
DOWEL PINS
WEIGHT
BEARING REMOVER
BOLTS
BEARING
11-5