Engine Hanger Bracket B; Swing Rod - Honda SH300 2006 Manual

Pack the new needle bearings with grease.
Drive the needle bearings into the engine hanger
bracket B with the marked side facing up until it is
fully seated, using the special tools.
TOOLS:
Driver
Attachment, 24 x 26 mm
Pilot, 20 mm
ENGINE INSTALLATION
• Route the wires, hoses and cables properly (page
1-19).
SWING ROD NUT (Upper)
42 N·m (4.3 kgf·m, 30 lbf·ft)
SWING ROD NUT (Lower)
52 N·m (5.3 kgf·m, 38 lbf·ft)
NEEDLE BEARINGS
INNER COLLAR
DUST SEALS
07749-0010000
07746-0010700
07746-0040500

SWING ROD

ENGINE REMOVAL/INSTALLATION
BEARING
FRAME PIVOT NUT
78 N·m (8.0 kgf·m, 58 lbf·ft)
ENGINE HANGER BRACKET A
ENGINE BRACKET NUT
64 N·m (6.5 kgf·m, 47 lbf·ft)

ENGINE HANGER BRACKET B

ENGINE PIVOT NUT
78 N·m (8.0 kgf·m, 58 lbf·ft)
DISTANCE COLLAR
DRIVER
ATTACHMENT/
PILOT
8-9