Honda SH300 2006 Manual page 453

ELECTRIC STARTER
Install a new O-ring to the starter motor case.
Install the front cover to the starter motor case.
FRONT COVER
When installing the front cover, take care to prevent
damaging the oil seal lip with the armature shaft.
O-RING
Align the index marks on the front cover, starter
motor case and rear cover.
Align
Install a new O-rings to the bolts.
Install and tighten the bolts to the specified torque.
TORQUE: 4.9 N·m (0.5 kgf·m, 3.6 lbf·ft)
BOLTS
INSTALLATION
Apply oil to a new O-ring and install it to the starter
STARTER MOTOR
motor groove.
O-RING
Install the starter motor to the crankcase.
Route the cable
properly (page 1-
19).
21-13