Radiator Cooling Fan; Radiator - Honda SH300 2006 Manual

RADIATOR COOLING FAN

REMOVAL/INSTALLATION
Remove the following:
– floor side cover (page 3-8)
– front inner cover (page 3-10)
– floor panel (page 3-13)
Disconnect the cooling fan motor 2P (black) connec-
tor and release the wire from the three wire bands.
Remove the two mounting bolts and fan motor
Be careful not to
assembly.
damage the radiator
fins.
Installation is in the reverse order of removal.
Route the fan
motor wire properly
TORQUE:
(page 1-19).
Cooling fan motor mounting bolt:

RADIATOR

REMOVAL/INSTALLATION
Remove the following:
– floor side cover (page 3-8)
– under cover (page 3-9)
– front inner cover (page 3-10)
– floor panel (page 3-13)
– cooling fan motor (page 7-13)
Drain the coolant from the system (page 7-7).
Disconnect the four water hoses.
Disconnect the radiator siphon hose.
Remove the two bolts and water pipe.
Remove the two mounting bolts and radiator.
Be careful not to
damage the radiator
fins.
Installation is in the reverse order of removal.
Route the wire
harness properly
• When installing the radiator, align the rubber of
(page 1-19).
the radiator and hole of the frame.
Fill and bleed the cooling system (page 7-6).
8.5 N·m (0.9 kgf·m, 6.3 lbf·ft)
COOLING SYSTEM
FAN MOTOR
WATER HOSES
BOLTS
WATER PIPE
BOLTS
RADIATOR
2P CONNECTOR
WIRE BANDS
BOLTS
SIPHON HOSE
7-13