Honda SH300 2006 Manual page 382

Table of Contents

HYDRAULIC BRAKE

Install the snap ring into the groove in the master

Snap ring pliers

• Install the snap ring with the chamfered edges

facing the thrust load side.

• Check that the snap ring is seated in the grooves.

Apply silicone grease to the piston boot inner sur-

Install the piston boot into the master cylinder and

the groove in the piston.

Instal the brake light/inhibitor switch and tighten the

screws to the specified torque.

TORQUE: 1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)

Apply 0.1 g of silicone grease to the contact sur-

faces of the brake lever, piston tip and brake lever

pivot bolt sliding surface.

Install the brake lever.

Install the pivot bolt and tighten it to the specified

TORQUE: 1 N·m (0.1 kgf·m, 0.7 lbf·ft)

Install the pivot nut and tighten it to the specified

TORQUE: 6 N·m (0.6 kgf·m, 4.4 lbf·ft)

07914-SA50001

BRAKE LIGHT/INHIBITOR SWITCH

SNAP RING PLIERS

Chapters

Table of Contents