Install Ground Stakes - KidKraft Cedar Summit Lookout Extreme Installation And Operating Instructions Manual

Step 24: Install Ground Stakes
A: In the 5 places shown in fig. 24.1 drive the Rebar Ground Stakes 13" into the ground against (142) Diagonal,
(072) Narrow Back Panel, (021) Left Access and both (213) SW Posts. Be careful not to hit the washer while
hammering stakes into the ground as this could cause the washer to break off.
B: Attach ground stakes using 1 (S7) #12 x 2" Pan Screw per ground stake as shown in fig. 24.2.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
be driven 13" into ground. Digging or driving stakes can be dangerous if you
do not check first for under-ground wiring, cables or gas lines.
Fig. 24.1
SEE FRONT COVER FOR
SAFETY CLEARANCE
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
FINAL LOCATION MUST BE LEVEL GROUND
Warning!
To prevent tipping and avoid potential injury, stakes must
081
5 x
EN71 version
213
Hardware
#12 x 2" Pan Screw
S7
59
F
ig. 24.2
Rebar Ground
Stake
Other Parts
5 x Rebar Ground Stake
S7