Install Ground Stakes - KidKraft COZY ESCAPE PLAYHOUSE F29045 Installation And Operating Instructions Manual

Step 42: Install Ground Stakes
A: In the 6 places shown in fig. 41.1 drive the Rebar Ground Stakes 13" (33cm) into the ground against (9265)
Folding Panel Assembly Left B, (9264) Folding Panel Assembly Left A, (9490) Groud Brace, (9491) Ground Brace
A. Be careful not to hit the washer while hammering stakes into the ground as this could cause the washer to
break off. (fig. 42.1 and 42.2)
B: Attach Ground Stakes using 1 (S7) #12 x 2" Pan Screw per ground stake as shown in fig. 42.3.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
Fig. 42.1
SEE FRONT COVER
FOR SAFETY CLEARANCE
replace image on pg 77 of V8
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
FINAL LOCATION MUST BE LEVEL GROUND
9490
Warning!
To prevent tipping and avoid potential
injury, stakes must be driven 13" (33cm) into ground.
Digging or driving stakes can be dangerous if you do not
check first for under-ground wiring, cables or gas lines.
9491
Hardware
6 x Pan Screw
S7
77
Fig. 42.2
S7
Rebar
Ground
Stake
Other Parts
6 x Rebar Ground Stake