Attach Swing End To Swing Beam - KidKraft BOULDER STATION Installation And Operating Instructions Manual

Step 5: Attach Swing End to Swing Beam
A: Place (4919) SW Rail Block in the centre between (1826) Front Beam and (1825) Back Beam and attach with
1 (H8) 1/4 x 4-1/4" Hex Bolt (with lock washer, flat washer and t-nut). (fig. 5.1 & 5.2)
B: Attach KidKraft Plaque over 1/4" t-nut on (1826) Front Beam with 4 (S18) #6 x 1" Wood Screws. (fig. 5.1 &
5.2)
Fig. 5.1
C: Attach Swing End Assembly to the side of the Swing Beam Assembly with the overhang (fig. 5.3 & 5.4) using
1 (G5) 5/16 x 4-1/2" Hex Bolt (with lock washer, flat washer and t-nut) in the top hole of Triangle Plate and 1 (G8)
5/16 x 2" Hex Bolt (with 2 flat washers and lock nut) in the bottom hole of Triangle Plate. (fig. 5.3) Make sure
Swing End Assembly flares out at an angle. (fig. 5.4)
D: Attach 2 Glider Hangers to the Swing Beam Assembly using 2 (G7) 5/16 x 5-1/2" Hex Bolt (with 2 flat washers
& lock nut) per Glider Hanger. (fig. 5.1 & 5.3)
Fig. 5.4
Side with
overhang
Wood Parts
1 x SW Rail Block 2 x 4 x 5-3/8"
4919
Glider
Hangers
WARNING:
Glider Hangers must be tight
and secure to Swing Beams.
Fig. 5.3
100°
1 x H8 1/4 x 4-1/4" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1 x G5 5/16 x 4-1/2" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
4 x 5/16 x 5-1/2" Hex Bolt (5/16" flat washer x2, 5/16" lock nut)
G7
1 x 5/16 x 2" Hex Bolt (5/16" flat washer x2, 5/16" lock nut) 5/16 x 2" Hex Bolt
G8
KidKraft
Plaque
1/4" Flat
Washer
1/4" Lock
Washer
H8
5/16" Lock
Washer
G8
5/16" Flat
Washer
5/16"
T-Nut
5/16"
Lock Nut
G7
Hardware
24
S18
Fig. 5.2
1/4"
T-Nut
G5
5/16"
5/16" Flat
Lock Nut
Washer
5/16" Flat
Washer
Glider
Hanger
Other Parts
2 x Glider Hangers
1 x KidKraft Plaque (with
hardware)
4919
1826
1825