Attach Tnr 4 Clamp Rings - KidKraft Cedar Summit Lookout Extreme Installation And Operating Instructions Manual

Step 74: Attach TNR 4 Clamp Rings
A: Place 2 TNR4 Clamp Rings around each joint on the top 4 slide sections making sure to match the arrows with
the end of the Clamp Ring as shown in fig. 74.1 and 74.2. On the final section, rotate the clamp ring as shown. (fig.
74.1 and 74.2)
B: Connect TNR4 Clamp Rings in 2 spots using 1 (PB6) ¼ x 1" Pan Bolt (with lock nut) per side. (fig. 74.2 & 74.3)
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the round
recess and the lock nuts go through the side with the hexagonal recess.
Fig. 74.1
TNR4
Clamp
Rings
TNR4
Clamp
Rings
Note: For ease of assembly
bottom set of clamp rings
can be rotated 90 degrees
to install bolts.
Fig. 74.2
PB6
After the clamp rings are attached to
the elbows, fasten them end to end
with two pan bolts and lock nuts
Hardware
10 x 1/4 x 1" Pan Bolt
PB6
(1/4" lock nut)
128
PB6
Lock
Nut
Make sure arrows
are aligned
Fig. 74.3
Lock
Nut
Other Parts
10 x TNR4 Clamp Ring