Table of Contents
Advertisement
» Chain Port
»» Port Name
»» Port Type
»» Port Speed
»» Modem Initialization
String
»» Initialize Modem
»» Flow Control
» SNMP
»» SNMP Access
»» SNMP Communities
IP Address
Privileges
Get Name
Set Name
61200266L1-1
Write security: 2; Read security: 5
Accepts input for configuring the Chain In port.
Write security: 2; Read security: 5
Defines the name of the chain port. Type in an alpha-numeric name up to 57
characters long. The name can include spaces and special characters.
Write security: 2; Read security: 5
Specifies whether you use
Write security: 2; Read security: 5
Specifies the baud rate of the port. Select either 2400, 9600, 19200, or 38400.
If you are using
for Port Type, ensure that the Port Speed setting
Dial
matches the modem baud rate.
Write security: 2; Read security: 5
Specifies the initialization string for a modem. Refer to your modem docu-
mentation for acceptable initialization strings.
Write security: 4; Read security: 5
Sends the Modem Initialization string to the modem. When you select this
command, the following message displays:
nected to the chain port before continuing. Confirm (y/n).ý
modem is connected before selecting
Write security: 2; Read security: 5
Sets the flow control for the Chain In port. You may configure the Chain In
port flow control for OFF or H/W (hardware).
Write security: 3; Read security: 5
Provides a way to configure SNMP access for the ATLAS 810
detailed information on SNMP, refer to SNMP Management on page 11-1.
The following options are available for review and editing:
Write security: 3; Read security: 5
Defines whether SNMP access to the ATLAS 810
Select the appropriate option.
Write security: 3; Read security: 5
Defines SNMP manager(s) characteristics as follows:
Specifies the IP address of the network manager.
Defines Get (read-only) and Get/Set (read and write) privileges.
Defines the community name for Get access. This value must match the Get
name defined on the network management station. Public is the default
name.
Defines the community name for Set access. This value must match either
the Get or Set name defined on the network management station. Public is
the default name.
ATLAS 810
Chapter 6. Terminal Menu and System Control
or
mode.
Direct
Dial
Please verify a modem is con-
.
Y
PLUS
User Manual
Ensure that a
PLUS
. For
PLUS
is enabled or disabled.
6-9
Advertisement
Table of Contents
