Octal Bri Module (User Termination) - ADTRAN ATLAS 810 Plus User Manual

Calls
D64, D56, Audio,
Speech

Octal BRI Module (User Termination)

»» Switch Type
»» SPID List
Phone Number
SPID Number
Calls
D64, D56, Audio,
Speech
61200266L1-1
The number of calls (1 or 2) which can be received or sent on this number/
SPID.
These options reflect what the Network has provisioned for this SPID. If the
BRI was purchased with different services provisioned for the SPIDs, then
the call must match the services supported.
The Octal BRI with a "U" interface acts as the Network while interfacing to
user equipment (terminal adapters). When you are working in the User Ter-
mination section of the Dial Plan menu and Slot is defined as a UBRI-8
module, the following interface configuration options are available:
Write security: 2; Read security: 5
Defines the type of ISDN switch that ATLAS will simulate. If connected to
another ATLAS, both need to be set to the same type. The available options
include Lucent 5E, Northern DMS 100, and National ISDN.
Write security: 2; Read security: 5
ATLAS, acting as the Network, must use a SPID and a phone number in or-
der to satisfy the ISDN connection protocol expected by the User's Terminal
Adapter (TA).
The phone number(s) assigned to this BRI phone line.
Defines the SPID number(s) which will be used for this BRI line. Although
the value of the SPID is not significant, a SPID must be entered for each
phone number. For convenience, the SPID can be set to be the same as the
phone number.
For User terminations, the number of calls is fixed at 2.
Reflects what the Network has provisioned for this SPID. If the BRI was pur-
chased with different services provisioned for the SPIDs, then the call must
match the services supported.
ATLAS 810
which some terminal adapters offer.
ATLAS 810
Chapter 9. Dial Plan Terminal Menu
PLUS
does not support autoSPID detection software
PLUS
User Manual 9-21