Table of Contents
Advertisement
Chapter 9. Dial Plan Terminal Menu
»» Accept Number
»» Search
Primary Search
Secondary Search
»» Data 64K, Data 56K,
Audio, Speech
»» Treat Call As
9-4
Designates which numbers this endpoint passes on toward the Network
(PSTN). The accept list may consist of multiple entries. The numbers are
defined using the following "wild cards":
X =
Any single digit
N = Any single digit 2—9
$ = Any number of digits of any value
9 = This specific number
[1,2,3...] = A single digit in this group
For example, 1-800-$ only permits toll free long distance calls to 1-800. If
this were used, then a second accept # would need to be specified
(NXX-XXXX) permitting local numbers to be dialed.
Any specific entry takes precedence over a wild card. For
example, if endpoint "A" was designated as $ while endpoint
"B" accepted 963-800X, then an incoming call to 963-800X
would only be accepted by endpoint "B."
Write Security: 3 Read Security: 5
Instructs ATLAS in which order to search for an accept number match. Nor-
mally, all searches are set to primary. The secondary search selection forces
ATLAS to only accept a call at this endpoint if all primary endpoints are
unavailable.
All long distance calls should go out a PRI directly to an IXC (MCI, ATT,
etc.), and local calls should go out a T1 to the LEC. It may be desirable to
place long distance calls on the local exchange if all of the IXC trunks are un-
available (busy or in alarm). In this case, the primary accept number for the
local exchange would be N$, and the secondary accept would be 1$.
The same accept rules apply for all secondary number searches as for prima-
ry searches.
Reflects the bearer capability the Network has provisioned for this line. If
the ISDN lines were purchased with different services provisioned, then
ATLAS would send the call out of the port which supports the type of ser-
vice the call requires.
For example, the Network termination is on a pair of BRIs (with the same
phone number) with one provisioned for data and the other for voice. By en-
abling data in one and not the other, ATLAS ensures that calls bearing data
will be sent out the right BRI interface.
Allows the incoming call t be treated as the selected call type, regardless of
the actual incoming call type. The default selection As Received effectively
disables the feature by using the actual call type.
PLUS
ATLAS 810
User Manual
61200266L1-1
Advertisement
Table of Contents
