Table of Contents
Advertisement
Chapter 9. Dial Plan Terminal Menu
9-28
Setting User Term Connections
Step
1
Navigate to User Term.
Enter connections for BRI D,E, and F in the same manner as BRI
2
A, B, and C: use the copy (C) and paste (P) commands to enter
the appropriate Out#Accept and Out#Reject numbers.
Ensure that the SPID and Phone entries under Ifce Config match
3
the SPID and phone numbers of the attached equipment.
Enter the connection for T1-A: select RBS under Sig, and enter
4
1-900-$ under Out#Reject.
5
Set Trunk Type (under Ifce Config) to Analog.
6
Set Signaling Method to E&M Wink.
7
Set DID (under Ifce Config) to enabled.
8
Set the DID Digits Transferred to 4.
When you complete the User Term Dial Plan, it appears as shown in Figure
9-7.
PLUS
ATLAS 810
Figure 9-6. Completed Network Map
Action
User Manual
61200266L1-1
Advertisement
Table of Contents
