Table of Contents
Advertisement
61200266L1-1
Instructions for Defining Data Connections (Continued)
Step
Paste this information onto a new connection line by positioning
6c
the cursor over the index numbers of the new connections, and
pressing
.
P
Modify these connection lines to complete the connections for
7
data.
Instructions for Defining Voice Connections
Step
Select the FROM Slot and Port for the first voice connection (i.e.,
1
Slot 0/Port 1 for T1-A Voice).
2
Select the voice DS0s; i.e., 1 through 8 for Voice A.
Select the TO Slot and Port (PBX Connection); i.e., Quad T1/PRI
3
in Slot 1/Port 2.
From Configuration, set the starting DS0 that these voice DS0s
4
will appear in; i.e., 1 for Voice A; 9 for Voice B; 17 for Voice C. (This
action sets the DACSing between the T1s.)
5
Set RBS to On for the voice connections.
(Optional) From Configuration, set the trunk conditioning
6
(Signaling and Data code) for T1 failure.
7
Repeat for the remaining voice connections.
A connection is not actually "made" (connected) until the cursor
leaves the connection. The cursor leaves the connection when you
press ESC to move the cursor to the index # or when you move the
cursor onto another connection line.
PLUS
ATLAS 810
Chapter 8. Dedicated Maps Terminal Menu
Action
Action
User Manual
8-9
Advertisement
Table of Contents
