Table of Contents
Advertisement
Chapter 9. Dial Plan Terminal Menu
»» Outgoing Caller ID
Send as provided
Substitute if not
present
ID Presentation
ID Number
Substitute always
ID Presentation
ID Number
»» Source ID
»» Swap ANI/DNIS
Quad T1/PRI Module (Network Termination/NFAS)
9-12
Write Security: 3 Read Security: 5
Inserts a called ID based on the following selections:
ATLAS forwards whatever ID it receives (including None).
ATLAS inserts a User-defined ID value if no value is received.
Sends to the Network control information for the presentation of Caller ID
(Presentation Allowed; Presentation Restricted; Number Not Available).
Value for Caller ID to be sent to the Network (i.e., 256 963 8020).
ATLAS always inserts the User-defined ID in place of the value received.
Same as above.
Same as above.
Simplifies the creation of a Dial Plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint origi-
nated the call.
•
Default value = 0. The default ID for all endpoints is 0 and for all accept
# s is 0. With default values, all calls are routed based only on dialed
number.
•
Multiple endpoints can have the same Source ID.
•
When creating the Call Accept list, specify a Source ID(s) as well as a
dialed number or range of dialed numbers to accept.
Say, for example, an application requires that all calls originating from
Port 1 of the Quad T1/PRI module in Slot 1 be switched to Port 4 of that
same module. Assign a unique Source ID (e.g., 7) to Port 1 of the module,
and then configure Port 4 to only accept calls from that unique Source ID
(7).
Swaps the ANI and DNIS numbers received from the Network. ANI (Auto-
matic Number Identification) is the billing number of the calling party, and
DNIS (Dialed Number Identification Service) is the called party number.
This swap causes the ATLAS switchboard to use ANI to route the
call. The accept number in the Dial Plan must use the ANI number,
not the DNIS number.
When you are working in the Network Termination section of the Dial Plan
menu, Slot is defined as a T1/PRI module, and Sig is set to NFAS, the fol-
PLUS
ATLAS 810
User Manual
61200266L1-1
Advertisement
Table of Contents
