Activate Time; Enbl Day - ADTRAN ATLAS 810 Plus User Manual

»» TO Slot
»» Port
»» To Config
»» SIG
» Activate Time
» Enbl Day
Example 1
61200266L1-1
Write security: 3; Read security: 5
Specifies the slot to use for the second end of a connection. Select this
option, and a list of all of the slots and the modules installed in the slots dis-
plays. Pick the appropriate slot.
Write security: 3; Read security: 5
Selects the port used for the second connection. When you select this
option, a list of all the slots and available modules displays. Select the
appropriate slot.
Write security: 3; Read security: 5
Specifies the configuration for the To connection. The selections that dis-
play in this field are based on the type of module selected in the TO Slot
option. You must input the following information (based on the type). The
same options for setting DS0s are available for this command as with the
FROM Config option.
Write security: 3; Read security: 5
(Signaling) Defines whether the connection has active RBS. Where RBS is
not an option, the ATLAS 810
For example, a T1-to-Nx connection is set to
Preserves the signaling bits between the connections.
RBS
Off Ignores signaling bits.
Write security: 3; Read security: 5
Sets the time when the map becomes active if you have selected Auto in the
Activate Map field (see Activate Map on page 8-2). Enter this time in
hh:mm:ss 24-hour format.
Write security: 3; Read security: 5
Specifies which days of the week the map is active.
Setting Trunk Conditioning
The trunk conditioning process sets known values in the signaling bits and
the data bits for outgoing DS0s which are cross-connected to a T1 port expe-
riencing alarms. The trunk conditioning process consists of a 2.5-sec trans-
mission (indicating call termination), followed by a continuous transmission
(signaling the final condition as chosen by the User).
Use the trunk conditioning menu items Fault Signaling (to set the state of
the signaling bits) and Fault Data Code (to set the state of the data bits) for
this process. You can set trunk conditioning for each end of each T1-to-T1
connection in a dedicated map. To simplify this procedure, use the copy
command (press C). Connections to the Network and connections to User
equipment (PBX) contain different signaling bit states.
ATLAS 810
Chapter 8. Dedicated Maps Terminal Menu
PLUS
automatically assigns the correct setting.
Off
PLUS
User Manual
.
8-5