If the adjustable frequency drive is supplied by DC or if the fan must run independently of the power supply, an external power supply can be applied.

The connection is made on the power card.

Terminal No.

100, 101

102, 103

The connector located on the power card provides the AC line voltage connection for the cooling fans. The fans are factory-equipped to be supplied from

a common AC line (jumpers between 100-102 and 101-103). If an external supply is needed, the jumpers are removed and the supply is connected to

terminals 100 and 101. A 5 Amp fuse should be used for protection. In UL applications, this should be a LittleFuse KLK-5 or equivalent.

4.6.13 Power and Control Wiring for Non-shielded Cables

Induced Voltage!

Run motor cables from multiple drives separately. Induced voltage from output motor cables run together can charge equipment

capacitors even with the equipment turned off and locked out. Failure to run output cables separately could result in death or serious

injury.

Run drive input power, motor wiring, and control wiring in three separate metallic conduits or raceways for high frequency noise

isolation. Failure to isolate power, motor, and control wiring could result in less than optimum controller and associated equipment

performance.

Because the power wiring carries high frequency electrical pulses, it is important that input power and motor power are run in separate conduit. If the

incoming power wiring is run in the same conduit as the motor wiring, these pulses can couple electrical noise back onto the building power grid. Control

wiring should always be isolated from the high voltage power wiring.

When shielded/armored cable is not used, at least three separate conduits must be connected to the panel option (see figure below).

•

Power wiring into the enclosure

•

Power wiring from the enclosure to the motor

•

Control wiring

Function

Auxiliary supply S, T

Internal supply S, T

MG.16.A1.22 - VLT