Entering Setup Parameters - GE DigitalFlow XGS868i Programming Manual

Appendix C. Programming the XGS868i Using PanaView™
C.5.5 Entering Setup Parameters
The signal limits and response times for the Model XGS868i are specified via the
programming instructions, refer to Figure 53 on page 140 of Appendix D, PanaView Menu Maps. This submenu
includes four options:
•
Signal - set the parameters related to the transducer signal
•
Default Setup - initialize all parameters to default values
•
V Averaging - specify the response of the meter to step changes
•
Advanced Features - enable mass flow or activate K factors.
To enter the Set Up submenu, highlight and double-click on the Set Up option in the center pane of the
Remember to record all programmed data in Appendix B, Data Records.
C.5.5a The Signal Option
Use this option to set the limits for the incoming signal and other parameters affecting the transducer signal. For
example, the programmed signal strength low limit may be used to determine the trigger point for an alarm.
CAUTION! The Signal default settings are suitable for most applications. Consult the factory
before changing any of these parameters.
Set Up
1. From the option menu, highlight and double-click on Signal in the center pane.
2. For each parameter, click [Next Item] to accept the current value or enter a new value and click [Next Item].
Table 20 on page 107 lists ranges and default parameters for each parameter.
106
SETUP
submenu. While following the
Channel
DigitalFlow™ XGS868i Programming Manual
menu.