Table of Contents
Advertisement
Appendix C. Programming the XGS868i Using PanaView™
Option Card RTD Inputs
o
o
Option cards with RTD inputs have a temperature range of –148
to 660
F (–100° to 350°C). Complete the following
steps to set up the RTD inputs of an option card installed in Slot 1 (refer to Figure 55 on page 142):
1. Double-click on the desired Input (A, B, C or D).
Note: The setup of RTD input A is used here as an example. Identical procedures would be used to set up the
remaining RTD inputs.
2. Enter a Label of up to eight characters for input A and click [Next Item].
3. Double-click on Off to disable Input A and return to step 1, or on Temp to enable input A as a live temperature
input.
4. Enter a temperature value for the Zero (low) end of the analog input range and click [Next Item].
5. Enter a temperature value for the Full Scale (high) end of the analog input range and click [Next Item].
After responding to the above prompt, the meter returns to step 1. Click [Exit Page] to proceed to another menu or
option.
120
DigitalFlow™ XGS868i Programming Manual
Advertisement
Table of Contents
