Adding The Xgs868I - GE DigitalFlow XGS868i Programming Manual

Appendix C. Programming the XGS868i Using PanaView™
C.3 Adding the XGS868i
To add the XGS868i on the IDM-configured communications port, complete the following steps:
1. Highlight the communication port to which the meter will be added by clicking on it, and then open the Edit menu
on the menu bar (if the communication port is not highlighted first, the New Meter option is not active in the Edit
menu).
2. Click on the New option in the Edit menu (see Figure 35).
3. After clicking on the New option, the Meter menu option appears. Click on this option to select it.
4. The New IDM Meter screen (shown in Figure 36) opens. Enter the Network ID number for the meter, and click
[OK].
92
Figure 35: New Option in the Edit Menu
Figure 36: New IDM Meter Screen
DigitalFlow™ XGS868i Programming Manual