GE DigitalFlow XGS868i Programming Manual page 20

Chapter 1. Programming Site Data
1.6.2a Path and Axial Lengths (cont.)
Note: If a spoolpiece was ordered with the meter, the transducer signal path length
(L)
length are engraved on the flowcell and/or are included in the documentation supplied with the meter. For
on-site transducer installations, refer to Appendix C, Measuring P and L Dimensions, in the Startup Guide.
8. In the same manner, enter the appropriate Axial Length L unit type and axial length of the ultrasonic signal, and
press [Enter].
9. Scroll to the desired Fluid Type and press [Enter]. Then do one of the following:
• OTHER
If was selected - proceed to Step 10.
• STEAM
If was selected - proceed to Step 11.
10. Use the arrow keys to enter the Fluid Soundspeed (in feet per second) in the gas to be measured and press [Enter].
11. Scroll to the appropriate choice to indicate whether you want Reynolds Correction, and press [Enter].
•
If Off is selected, go to Step 12.
•
If On is selected, the program asks for the Kinematic Viscosity. Use the arrow keys to enter the desired value, and
press [Enter].
12. Use the arrow keys to enter a value for the flow Calibration Factor and press [Enter]. The default value is 1.00, but
values between 0.50 and 2.0 may be entered. The value is typically set at the factory, based on application details.
Procedure Options
After entering the Calibration Factor, the XGS868i returns to the
•
To continue entering "quick startup" data, press [
.
Data on page 21
•
To continue regular programming, refer to Appendix A, Menu Maps, to navigate to the desired menu.
•
To leave the Keypad Program, press the
10
Channel PROGRAM
Escape]
once and proceed to Step 1 in Entering Global System
[Escape]
key twice.
(P)
and the transducer signal axial
. Do one of the following:
DigitalFlow™ XGS868i Programming Manual