GE DigitalFlow XGS868i Programming Manual page 29

1.8.4c Activating Mass Flow
Use this option to calculate mass flow from a static fluid density. Complete the following steps to enter the static
density of the fluid:
IMPORTANT:
The Model XGS868i calculates the actual density from the live or fixed temperature and pressure inputs,
as programmed in the
value and uses the density entered at the following prompt to calculate mass flow.
1. In the Keypad Program, scroll to PROG and press [Enter].
2. In the PROG menu, scroll to CH1 or CH2 and press [Enter].
3. In the Channel PROGRAM menu, scroll to Setup and press [Enter].
4. Scroll to ADVAN. Press [Enter].
5. Scroll to MASS, and press [Enter].
6. Scroll to Yes to activate, or to No to deactivate Static Density, and press [Enter].
Note: If you scroll to No, go to Procedure Options below.
7. Enter the Fluid Density and press [Enter].
Procedure Options
After completing the steps on the previous page, the XGS868i returns to the Advanced Features window. Do one of
the following:
•
To continue programming, refer to Appendix A, Menu Maps, to navigate to the desired menu.
•
To leave the Keypad Program, press [Escape] five times.
DigitalFlow™ XGS868i Programming Manual
I/O
menu. However, setting the
Chapter 1. Programming Site Data
Mass flow calculation
prompt to
Yes
overrides this
19