Option Bar
CNTup
Displays AGC DAC count for upstream gain setting.
CNTdn
Displays the AGC DAC count for the downstream gain setting.
P#up
Displays signal peaks for the upstream transducer.
P#dn
Displays signal peaks for downstream transducer.
TEMP
Displays the gas temperature (from 0/4-20 mA input).
PRESR
Displays the gas pressure (from 0/4-20 mA input).
AcVOL
Displays actual volumetric flow.
StVOL
Displays standard volumetric flow.
z
Displays the compressibility factor.
Displays Skan transit time upstream.
2
Tu S
Displays Skan transit time downstream.
2
Td S
Displays Skan Delta T.
2
DT S
Displays Measure transit time upstream.
2
Tu M
Displays Measure transit time downstream.
2
Td M
Displays Measure Delta T.
2
DT M
Vinst
Displays the instantaneous velocity.
Displays the saturation temperature for steam at the current pressure.
TSat
Displays actual temperature minus the saturation temperature (Tac-
TSupr
tual – Tsat).
Rho
Displays fluid density.
Kelvn
Displays the current process temperature in °K.
kPa
Displays the current process pressure in kPa
Displays the steam quality from a live input or a static programmed
Qual
value.
1
available only if Multi K-factors = ON
Note: The measurement units that appear in these prompts are those selected in the
this section.
Procedure Options
After completing the above steps, the XGS868i returns to the I/O window. Do one of the following:
•
To continue programming, refer to Appendix A, Menu Maps, to navigate to the desired menu.
To leave the Keypad Program, press [Escape] three times.
•
DigitalFlow™ XGS868i Programming Manual
Table 9: Available Measurement Parameters (cont.)
Description
Chapter 1. Programming Site Data
100-2300
100-2300
2
available only if Burst Mode = S/M
Global-System
Good
Bad
N.A.
N.A.
N.A.
N.A.
<100 or >2300
<100 or >2300
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
0 – 1
<0 or >1
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
0
<0
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
0.0 – 1.0
<0.0 or >1.0
window earlier in
27