GE DigitalFlow XGS868i Programming Manual page 134

Appendix C. Programming the XGS868i Using PanaView™
C.6.2c Programming the LCD
Through PanaView, you can program the LCD display to display up to four variables in sequence. Complete the
following steps to program the LCD display:
Note: When you first initialize the XGS868i, the number of LCD parameters is set to OFF. You must program the
LCD to display any measured parameters.
1. From the Input/Output option, highlight and double-click on the Display option in the center pane.
2. The first prompt asks for the # of LCD Parameters. Double-click on the desired number (from
and KEY).
The OFF setting switches the measurement display off, while the KEY setting enables users to change the measurement
display via the arrow keys, without accessing the Keypad Program. If you select KEY:
•
To view a parameter other than the one currently displayed, press the [] or [] keys to scroll through the various
parameters.
•
To scroll through the channel options on a two-channel XGS868i, press the [] or [] keys until you have reached
the desired option.
Note: For a 1-channel XGS868i, skip to step 4.
3. Scroll to the desired Channel option, as listed in Table 30.
4. For each channel, select the desired Measurement Parameter, as shown in Table 27 on page 117.
5. Repeat steps 3 and 4 for each parameter. PanaView returns to the Global I/O menu.
124
Table 30: Channel Options
Option Description
CH1 Channel 1
CH2 Channel 2
SUM CH1+CH2
DIF CH1-CH2
AVE (CH1+CH2)/2
OFF through 1-4
LCD
DigitalFlow™ XGS868i Programming Manual