Advertisement
Configuration Utility
Setup
Selecting the Desired
Measurements
913-326A
The following is an example setup using National Instruments
Configuration Utility v3.1.
Figure 2 below shows the Configuration Utility with an XMT868 flow
meter on the network (GE Flow-XMT).
Figure 2: Configuration Utility Setup Example
Note: The following procedures assume that the device has been placed
in the OOS (out-of-service) mode before executing.
To set the measurement unit for each AI:
1. Double click on the FLOW Transducer Block (in the tree under
GEFlow-XMT).
2. Select the Others tab and open the drop down list for the
PRIMARY_SELECTOR and SECONDARY_SELECTOR (see Figure 3 on
page 4).
3. Choose the unit from the list (see Figure 3 on page 4).
This unit will correspond to the unit that is available in the AI block for
network connection. The PRIMARY_SELECTOR unit will correspond to
ANALOG_INPUT_1 and the SECONDARY_SELECTOR will correspond to
ANALOG_INPUT_2.
November 2005
3 of 7
Advertisement
