Wlan Rogue-Detect Rogue-Ap - 3Com 3CRUS2475 Command Reference Manual

wlan rogue-detect
rogue-ap
The following example defines the scanning interval for rogue APs at 150
seconds.
Console (Config-ap)# interface radio 802.11g
Console (Config-ap-radio-if)# rogue-detect rogue-scan-inter-
val medium
The wlan rogue-detect rogue-ap Global Configuration mode
command sets the status of rouge APs. To restore defaults, use the no
form of this command.
Syntax
wlan rogue-detect rogue-ap mac-address state {known | mitigate}
no wlan rogue-detect rogue-ap mac-address state
Parameters
mac-address — The rogue AP MAC address.
■
known — Specify that the rogue AP is known.
■
mitigate — Specify that the rogue AP should be mitigated.
■
Default Configuration
New.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the status of rogue AP with the MAC address
00-9E-92-4C-73-FCas known.
Console (config-ap)# wlan rogue-detect rogue-ap
00-9E-92-4C-73-FC state known

wlan rogue-detect rogue-ap

325