Qos Aggregate-Policer - 3Com 3CRUS2475 Command Reference Manual

128 C 9: Q
HAPTER O
qos
aggregate-policer
S C
OMMANDS
Example
The following example attaches a policy map called 'policy1' to the input
interface.
Console(config-if)# service-policy input policy1
The qos aggregate-policer Global Configuration mode command
defines the policer parameters that can be applied to multiple traffic
classes within the same policy map. To remove an existing aggregate
policer, use the no form of this command.
Syntax
qos aggregate-policer aggregate-policer-name committed-rate-bps
excess-burst-byte exceed-action {drop | policed-dscp-transmit}
no qos aggregate-policer
Parameters
aggregate-policer-name — Specifies the name of the aggregate
■
policer.
committed-rate-bps — Specifies the average traffic rate (CIR) in bits
■
per second (bps).
excess-burst-byte — Specifies the normal burst size (CBS) in bytes.
■
drop — Indicates that when the rate is exceeded, the packet is
■
dropped.
policed-dscp-transmit — Indicates that when the rate is exceeded,
■
the DSCP of the packet is remarked.
Default Configuration
No aggregate policer is defined.
Command Mode
Global Configuration mode
User Guidelines
Policers that contain set or trust Policy-map Class Configuration
commands or that have ACL classifications cannot be attached to an
output interface.