Switchport General Pvid - 3Com 3CRUS2475 Command Reference Manual

462 C 33: VLAN C
HAPTER
switchport general
pvid
OMMANDS
User Guidelines
This command enables changing the egress rule (for example from
tagged to untagged) without first removing the VLAN from the list.
Example
The following example adds VLANs 2, 5, and 6 to the allowed list of
Ethernet port 1.
Console(config)# interface ethernet 1
Console(config-if)# switchport mode general
Console(config-if)# switchport general allowed vlan add 2,5-6
tagged
The switchport general pvid Interface Configuration mode command
configures the PVID when the interface is in general mode. To restore the
default configuration, use the no form of this command.
Syntax
switchport general pvid vlan-id
no switchport general pvid
Parameters
vlan-id — Specifies the PVID (Port VLAN ID).
■
Default Configuration
If the default VLAN is enabled, PVID = 1. Otherwise, PVID=4095.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.