Radius Command; Radius-Server Host - 3Com 3CRUS2475 Command Reference Manual

17

radius-server host

RADIUS C
The radius-server host Global Configuration mode command specifies
a RADIUS server host. To delete the specified RADIUS host, use the no
form of this command.
Syntax
radius-server host {ip-address | hostname} [auth-port
auth-port-number] [timeout timeout] [retransmit retries] [deadtime
deadtime] [key key-string] [source source] [priority priority] [usage
type]
no radius-server host {ip-address | hostname}
Parameters
ip-address — IP address of the RADIUS server host.
■
hostname — Hostname of the RADIUS server host. (Range: 1-158
■
characters)
auth-port-number — Port number for authentication requests. The
■
host is not used for authentication if the port number is set to 0.
(Range: 0-65535)
timeout — Specifies the timeout value in seconds. (Range: 1-30)
■
retries — Specifies the retransmit value. (Range: 1-10)
■
deadtime — Length of time in minutes during which a RADIUS server
■
is skipped over by transaction requests. (Range: 0-2000)
key-string — Specifies the authentication and encryption key for all
■
RADIUS communications between the device and the RADIUS server.
This key must match the encryption used on the RADIUS daemon. To
specify an empty string, enter "". (Range: 0-128 characters)
OMMAND