Port Storm-Control Include-Multicast (Gc) - 3Com 3CRUS2475 Command Reference Manual

94 C 5: E
HAPTER THERNET
port storm-control
include-multicast
(GC)
C C
ONFIGURATION OMMANDS
Field
InBcastPkts
OutOctets
OutUcastPkts
OutMcastPkts
OutBcastPkts
FCS Errors
Single Collision
Frames
Late Collisions
Excessive Collisions
Oversize Packets
Internal MAC Rx
Errors
Received Pause
Frames
Transmitted Pause
Frames
The port storm-control include-multicast Interface Configuration
mode command enables counting multicast packets in the port
storm-control broadcast rate command. To disable counting multicast
packets, use the no form of this command.
Syntax
port storm-control include-multicast
no port storm-control include-multicast
Default Configuration
Multicast packets are not counted.
Command Modes
Interface Configuration (Ethernet) mode
Description
Counted received broadcast packets.
Counted transmitted octets.
Counted transmitted unicast packets.
Counted transmitted multicast packets.
Counted transmitted broadcast packets.
Counted received frames that are an integral number of
octets in length but do not pass the FCS check.
Counted frames that are involved in a single collision, and
are subsequently transmitted successfully.
Number of times that a collision is detected later than one
slotTime into the transmission of a packet.
Number of excessive collisions received on the selected
interface.
Counted frames received that exceed the maximum
permitted frame size.
Counted frames for which reception fails due to an
internal MAC sublayer received error.
Counted MAC Control frames received with an opcode
indicating the PAUSE operation.
Counted MAC Control frames transmitted on this
interface with an opcode indicating the PAUSE operation.