Spanning-Tree Port-Priority - 3Com 3CRUS2475 Command Reference Manual

spanning-tree
port-priority
Gigabit Ethernet (1000
Mbps)
Fast Ethernet (100 Mbps)
Ethernet (10 Mbps)
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The path cost method is configured using the spanning-tree pathcost
method Global Configuration mode command.
Example
The following example configures the spanning-tree cost on Ethernet
port g15 to 35000.
Console(config)# interface ethernet g15
Console(config-if)# spanning-tree cost 35000
The spanning-tree port-priority Interface Configuration mode
command configures port priority. To restore the default configuration,
use the no form of this command.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
Parameters
priority — The priority of the port. (Range: 0-240 in multiples of 16)
■
Default Configuration
The default port priority for IEEE Spanning TreeProtocol (STP) is 128.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.

spanning-tree port-priority

20,000
200,000
2,000,000
215
4
19
100