3Com 3CRUS2475 Command Reference Manual page 311

arp
IP address I/F
-------------
10.7.1.192/24 1
10.7.2.192/24 2
The arp Global Configuration mode command adds a permanent entry in
the Address Resolution Protocol (ARP) cache. To remove an entry from the
ARP cache, use the no form of this command.
Syntax
arp ip_addr hw_addr {ethernet interface-number | vlan vlan-id |
port-channel port-channel number.}
no arp ip_addr {ethernet interface-number | vlan vlan-id |
port-channel port-channel number.}
Parameters
ip_addr — Valid IP address or IP alias to map to the specified MAC
■
address.
hw_addr — Valid MAC address to map to the specified IP address or IP
■
alias.
interface-number — Valid Ethernet port.
■
vlan-id — Valid VLAN number.
■
port-channel number. — Valid port-channel number.
■
Default Configuration
This command has no default configuration.
Command Mode
Global Configuratin mode
User Guidelines
The software uses ARP cache entries to translate 32-bit IP addresses into
48-bit hardware addresses. Because most hosts support dynamic
resolution, static ARP cache entries do not generally have to be specified.
Type Direct
Broadcast
--------- --------------
--
Static disable
Static disable
arp 311