Configuring An Aggregate Interface; Configuring The Description Of An Aggregate Interface; Enabling Linkup/Linkdown Trap Generation For An Aggregate Interface - 3Com 4210G Series Configuration Manual

To do...
Assign the port a LACP
priority
Removing a dynamic aggregate interface also removes the corresponding aggregation group. At
the same time, the member ports of the aggregation group, if any, leave the aggregation group.
To guarantee a successful dynamic aggregation, ensure that the peer ports of the ports
aggregated at one end are also aggregated. The two ends can automatically negotiate the
selected state of the ports.

Configuring an Aggregate Interface

You can perform the following configurations for an aggregate interface:

Configuring the Description of an Aggregate Interface

Enabling LinkUp/LinkDown Trap Generation for an Aggregate Interface

Shutting Down an Aggregate Interface
Configuring the Description of an Aggregate Interface
Follow these steps to configure the description of an aggregate interface:
To do...
Enter system view
Enter Layer 2 aggregate
interface view
Configure the description of
the aggregate interface
Enabling LinkUp/LinkDown Trap Generation for an Aggregate Interface
To enable an aggregate interface to generate linkUp/linkDown trap messages when the state of the
interface changes, you should enable linkUp/linkDown trap generation on the aggregate interface.
Use the command...
lacp port-priority
port-priority
Use the command...
system-view
interface bridge-aggregation
interface-number
description text
2-8
Remarks
Optional
By default, the LACP priority of a port
is 32768.
Changing the LACP priority of a port
may affect the selected/unselected
state of the ports in the dynamic
aggregation group.
Remarks
—
—
Optional
By default, the description of an
interface is interface-name
Interface, such as
Bridge-Aggregation1 Interface.