Rear Panel Connections And Interface Board - Ametek 5800 User Manual

TERMINAL COVER
POWER
1
Figure 3-2.
Model 5830 rear
panel connections
and inside of dryer
compartment.
3-6 | 5830 Moisture Analyzer
5
4
- 3
SIGNAL
n s tru ent Air
0- 00
2

Rear Panel Connections and Interface Board

See Figures 3-2 and 3-3 for location of analyzer connections on rear panel
and interface board. Remove terminal cover to access interface board.
# Item
1 Power Conduit
2 Signal Conduit
3 Instrument Air Fitting
4 RS-232 Serial Port
5 Exhaust Fitting
6 Sample Inlet Fitting
aust a le n
ut 0-50
At os eri
ressure
3
Function
Cable gland for analyzer power cord.
Cable gland for signal connections.
Input port for instrument air used to
operate internal diaphragm valves; 1/4-
inch Swagelok fitting.
User serial communications interface.
Serial wiring supplied by user. Observe
caution regarding use in hazardous loca-
tions.
Vent port for cell exhaust; 1/4-inch male
VCR connector.
Input port for sample gas; 1/4-inch male
VCR connector.
6
DRYER COMPARTMENT
COVER