Ametek 5800 User Manual page 56

4-12 | 5830 Moisture Analyzer
Production Codes
Use this function to enter the production codes for the moisture generator
and reference dryer.
Config
Production
Codes
Generator
The production code for the moisture generator is required for proper op-
eration of the analyzer. This number contains the nominal output of the
device, which is used to determine the analyzer span settings.
Reference Dryer
The dryer production code is required for proper operation of the ana-
lyzer. This number contains the dryer capacity value, which is used to
estimate the life expectancy of the device.
Use caution, as entering a "new" value informs the analyzer that a

new dryer has been installed in the reference leg of the analyzer. The
remaining dryer capacity is reset when a new number is entered.
NOTE
Moisture Units
Select Units
Config
Moisture Unit Select Unit
The units for the moisture readings can be selected from a list. Pressing
Enter at the "Select Units" prompt displays the list. (If a dew/frost point is
selected, you must enter a value for the process pressure in units of kPa.

If you change the moisture units, remember to make the necessary
changes to the Alarm and Analog Range settings.
NOTE
Generator
Reference
Dryer
PPMV
PPBV
Pressure (KPa)*
Centigrade
Pressure (KPa)*
Fahrenheit