Communication Connections (Figure 3-9) - Ametek 5800 User Manual

GROUND STUDS
Figure 3-8.
Attach ground wire
to threaded chassis
stud.
Figure 3-9.
Communication
connections on
the 5830 analyzer
interface board.
RS-232
Instrument Air
80 - 100 PSIG
7. Reconnect 1 (L) and 2 (N) wires (Figure 3-7) by screwing in the two
plug screws. Make the ground connection to the threaded chassis stud
(Figure 3-8). Do not use the ground position on the power connector.
Plug in the power connector.
8. Connect a proper, locally recognized plug or terminator to the end of
your cord.
9. Replace rear cover.
10. Reconnect power.
LINE VOLTAGE
10
Line Voltage Selector
FUSE
9
Fuse Receptacle
L N G
8
Power Connector
1 2 3

Communication Connections (Figure 3-9)

1. Remove terminal cover.
2. Disconnect the power from the analyzer and remove the rear panel
terminal cover.
Exhaust
Sample In
Out
20-50 PSIG
Atmospheric
Pressure
TB1
TB2
DATA CONC SYSTEM
VALID ALARM ALARM
1 2 3 4 5 6 7
14
Alarm & Alert Contacts
Installation & Start-Up | 3-13
DRYER COMPARTMENT
COVER
RS-485
TERMINATOR
ON
ON
11
TB3
RS-485
ANALOG
OUTPUT
Terminator
RD TD
- + + - + -
OUT IN
12
RS-485
8 9 10 11 12 13 14 Serial Port
13
Analog Output