Table of Contents
Advertisement
The addresses are displayed at the one or more of the following (it depends on
the behavior of the UEFI driver included in each controller).
1. The addresses are displayed at the UEFI driver menu included in each
controller in the Configuration menu.
2. Select the UEFI driver menu included in each controller. The addresses are
displayed at the help for the UEFI driver menu included in each controller.
3. Enter the Network Device List menu. The addresses are displayed in the
Network Device List menu.
Only network controllers supporting the Command Line Protocol (CLP)
will be displayed.
5.3.15.4
Looking for the GUID address of an infiniband or Omni-Path
controller
▶ If available, check the label on the controller. Beside the part number, you
may find the GUID address.
▶ Inform the customer about the new or changed GUID address.
5.3.15.5
Looking for SAS addresses of SAS controllers for external
devices
These addresses can be found using the ServerView RAID Manager.
▶ Start the ServerView RAID Manager and log in.
▶ Select the desired SAS controller.
In the General tab you can find data on the selected object including its SAS
address.
For more information, see the "ServerView Operations Manager -
Server Management" user guide and the "ServerView RAID
Manager" user guide.
▶ Inform the customer about the new SAS address. The customer need the
new SAS address, especially when the server is connected to a Fujitsu
Storage ETERNUS system.
RX4770 M6
Upgrade and Maintenance Manual
Basic software procedures
109
Advertisement
Table of Contents
