Table of Contents
Advertisement
Processor (CPU)
Note when tightening the screws of the CPU heat sink:
▶ As shown in the figure below, tighten the screws while checking the screw
tip until it is visible through the screw hole.
▶ When you reach the above position, hold the screw driver with two fingers
and tighten the screw firmly.
Upgrading the main memory
▶ Select an adequate memory configuration for "4 CPUs populated", see
"Basic information" on page
▶ Install memory modules, see
At least you need to install one DIMM memory module per CPU as
minimum configuration.
Concluding steps
▶
"Installing the air duct 1 (top system board)" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
268
256.
"Installing a memory module" on page
53.
59.
Upgrade and Maintenance Manual
245.
71.
RX4770 M6
Advertisement
Table of Contents
