Table of Contents
Advertisement
System board and components
Figure 212: Removing the TPM spacer
▶ Using a flat nose pliers, press together the hooks on the TPM spacer (1, see
close-up) and remove it from the system board (2).
If the TPM is to be replaced, the TPM spacer may remain on the
system board.
Concluding steps
▶ Install the bottom system board, see
board" on page
▶ If applicable, install the OCP module, see
page
189.
▶ Install the power distribution board, see
distribution board" on page
▶ Connect the front panel cable from the bottom system board, see
the COP" on page
▶ If applicable, install the expansion cards from slot 3 to slot 9, see
the expansion card" on page
▶
"Installing the OCP air duct" on page
▶
"Installing the air duct 2 (bottom system board)" on page
340
383.
132.
320.
194.
Upgrade and Maintenance Manual
"Installing the new bottom system
"Installing the OCP module" on
"Installing the new power
73.
"Installing
"Installing
72.
RX4770 M6
Advertisement
Table of Contents
