Table of Contents
Advertisement
Figure 162: Applying the thermal paste
▶ Apply a small point-shaped amount of thermal paste (1.0 gram, see
description above) to the center of the heat sink lower surface as shown.
CAUTION
▶
Do not mix different types of thermal paste.
Installing the CPU and heat sink
▶ Confirm that the CPU model number printed on the top of the CPU fits with
the requirements.
▶ If applicable, remove the protective cap from the bottom side of the new
CPU.
▶ Install the CPU, see
▶ Install the heat sink, see
Concluding steps
For CPU 1 and 2 (bottom system board):
▶
"Installing the air duct 2 (bottom system board)" on page
▶
"Installing the top system board carrier" on page
RX4770 M6
"Installing the CPU" on page
"Installing the heat sink" on page
Upgrade and Maintenance Manual
Processor (CPU)
260.
262.
72.
76.
275
Advertisement
Table of Contents
