Table of Contents
Advertisement
Processor (CPU)
Tools:
– Phillips PH2 / (+) No. 2 screw driver (for cover 2)
– Torx 30 screw driver (for CPU heatsink)
CAUTION
CPUs are extremely sensitive to electrostatic discharge and therefore
must always be handled with care.
▶
After a CPU has been removed from its protective sleeve or from its
socket, place it upside down on a nonconducting, antistatic surface.
▶
Never push a CPU over a surface.
In case of dealing with CPUs in a liquid cooling configuration, see
"Liquid cooling (LC)" on page
Preliminary steps
For CPU 1 and 2 (bottom system board)
▶
"Locating the defective server" on page
▶
"Suspending BitLocker functionality" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Removing a riser module" on page
▶
"Removing the air duct 1 (top system board)" on page
▶
"Removing the top system board carrier" on page
▶
"Removing the air duct 2 (bottom system board)" on page
For CPU 3 and 4 (top system board)
▶
"Locating the defective server" on page
▶
"Suspending BitLocker functionality" on page
▶ If applicable,
"Removing the front cover with lock" on page
270
277.
46.
63.
Upgrade and Maintenance Manual
97.
81.
47.
48.
68.
73.
97.
81.
45.
69.
45.
RX4770 M6
Advertisement
Table of Contents
