Table of Contents
Advertisement
System board and components
Replacing the microSD card
▶ Remove the Dual microSD 64GB Enterprise, see
microSD 64GB Enterprise" on page
▶ Remove the defective microSD card from the Dual microSD 64GB
Enterprise.
Proceed as described in the following:
▶ To eject the defective microSD card, gently push it in and then let go, see
Figure
227.
▶ Pull the microSD card straight out of its slot.
CAUTION
The microSD card contains customer information.
▶
After removing the microSD card, hand the card over to the
customer.
▶
If the customer requests disposal of the defective microSD
card, proceed as follows: Using a pair of side-cutting pliers,
cut the microSD card in half.
▶ Install the new microSD card on the Dual microSD 64GB Enterprise.
Proceed as described in the following:
▶ With the label facing up, insert the microSD card into the microSD slot on
the controller until it locks in place (see
▶ Install the Dual microSD 64GB Enterprise, see
64GB Enterprise" on page
Concluding steps
▶ Install the riser module for PCIe slot 10 and PCIe slot 11, see
riser module" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
370
365.
361.
63.
53.
59.
60.
Upgrade and Maintenance Manual
"Removing the Dual
Figure
228).
"Installing the Dual microSD
61.
"Installing a
RX4770 M6
Advertisement
Table of Contents
