Table of Contents
Advertisement
System board and components
▶ Connect all cables to the system board:
– COP cable (front panel cable)
– Power cable for HDD backplane
– SATA cable for ODD
–SATA power cable for ODD
– Front VGA cable
– OOB cable
For the cable plan, see
Concluding steps
▶ If applicable, install the Dual microSD 64GB Enterprise, see
Dual microSD 64GB Enterprise" on page
▶ If applicable, install all M.2 SSDs, see
▶ If applicable, install the iRMC microSD card, see
microSD card" on page
▶ If applicable, install the TPM, see
▶ If applicable, install the OCP module, see
page
189.
▶ Install all memory modules on the bottom system board, see
memory module" on page
Ensure that you reinstall each memory module in the slot it was
located before the replacement.
CAUTION
In case of Optane PMem modules are not reinstalled in the right
slots, data can be lost!
▶ Install all memory dummy modules on the bottom system board, see
"Installing a dummy module" on page
▶ Install the power distribution board, see
board" on page
▶ If applicable, install the expansion cards from slot 3 to slot 9, see
an expansion card" on page
384
"Appendix A" on page
345.
245.
129.
194.
Upgrade and Maintenance Manual
387.
361.
"Installing the M.2 SSD" on page
"Installing the iRMC
"Installing the TPM" on page
"Installing the OCP module" on
253.
"Replacing the power distribution
"Installing the
353.
332.
"Installing a
"Installing
RX4770 M6
Advertisement
Table of Contents
