Removing A Gpu Card From A Riser Module - Fujitsu PRIMERGY RX4770 M6 Upgrade And Maintenance Manual

Expansion cards and backup units
9.8.2

Removing a GPU card from a riser module

Upgrade and Repair Unit
(URU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Suspending BitLocker functionality" on page
▶ If
applicable,"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove the corresponding riser module, see
page 63.
Removing a GPU card
▶ Disconnect the GPU PWR cable from the bottom system board.
▶ Remove the GPU air duct.
Figure 127: Removing the GPU from the riser module
222
46.
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
81.
47.
48.
"Removing a riser module" on
45.
RX4770 M6