Terminal Block Power Supply; 0Tb103.9X; Order Data; Technical Data - B&R Automation Panel 9 D Series User Manual

Accessories

9.3 Terminal block power supply

9.3.1 0TB103.9x

9.3.1.1 Order data

Model number Short description
Accessories
0TB103.9 Connector 24 VDC - 3-pin, female - Screw clamp terminal block
3.31 mm²
0TB103.91 Connector 24 VDC - 3-pin, female - Cage clamp terminal block
3.31 mm²

9.3.1.2 Technical data

Information:
The following specified characteristic data, features and limit values are only valid for this accessory
and may differ from those of the complete system. The data specified for the complete system applies
to the complete system in which this accessory is installed, for example.
Model number
General information
Certifications
CE
UL
HazLoc
DNV GL
KR
EAC
Terminal block
Note
Number of pins
Type of terminal block
Cable type
Pitch
Connection cross section
AWG wire
Wire end sleeves with plastic covering
Solid wires
Fine-stranded wires
With wire end sleeves
Tightening torque
Electrical properties
Nominal voltage
Nominal current
4)
Contact resistance
Operating conditions
Pollution degree per EN 61131-2
1) Yes, but applies only if all components installed in the complete system have this certification and the complete system bears the corresponding mark.
2) Yes, but applies only if all components installed in the complete system have this certification and are listed on the associated DNV GL certificate for the
product family.
3) The cage clamp terminal block cannot be used side by side.
4) The respective limit data of the I/O modules must be taken into account!
130
0TB103.9
Screw clamp terminal block variant
26 to 14 AWG
0.20 to 1.50 mm²
0.4 Nm
Table 50: 0TB103.9, 0TB103.91 - Technical data
Yes
cULus E115267
Industrial control equipment
cULus HazLoc E180196
Industrial control equipment
for hazardous locations
Class I, Division 2, Groups ABCD, T4
Temperature: B (0 - 55°C)
Humidity: B (up to 100%)
Vibration: A (0.7 g)
EMC: B (bridge and open deck)
Yes
Yes
Protected against vibration by the screw flange
Nominal data per UL
3 (female)
Cage clamp terminal block variant
Only copper wires (no aluminum wires!)
5.08 mm
0.20 to 1.50 mm²
0.20 to 2.50 mm²
0.20 to 1.50 mm²
300 V
10 A / contact
≤5 mΩ
Pollution degree 2
Automation Panel 9xD - Hygienic design User's manual V 1.80
Figure
0TB103.91
1)
2)
3)
26 to 12 AWG
0.20 to 2.50 mm²
-