Memory Organization - B&R Automation Panel 9 D Series User Manual

Command Description
Set_DSFID Writes the DSFID value
Lock_Block Enables write protection for a block
Lock_AFI Sets AFI write protection
Lock_DSFID Sets DSFID write protection
Connect Connects manually to a specific tag
Disconnect Automatically restores a connection to the best tag
Inventory Reads the UID and DSFID from the PICC
Stay_Quiet PICC enters quite mode
Reset_To_Ready PICC exits quiet mode
Reset_Quiet All PICCs exit quiet mode
Information:
For additional information about flags, see

7.4.4.2 Memory organization

Source and destination block = 0 to 254 (depends on the tag)
Data and key = 00 to FF (no leading "0x", bytes can optionally be separated by a space)
Value = 1 byte including sign bit
All commands and parameters are in ASCII. Data is in 00h hex format.
Automation Panel 9xD - Hygienic design User's manual V 1.80
Parameter 1
Flags (flag)
Flags (flag)
Flags (flag)
Flags (flag)
8-byte SNr
--
Flags (flag)
Flags (flag)
Flags (flag)
--
Table 41: ISO 15693 commands
"Flag definitions".
Parameter 2 Parameter 3 Parameter 4
1-byte value -- --
Target block -- --
-- -- --
-- -- --
-- -- --
-- -- --
AFI Bit length Mask
Serial number -- --
Serial number -- --
-- -- --
Software
Parameter 5
--
--
--
--
--
--
--
--
--
121