Buttons; Slot For Memory Card - Siemens SINAMICS Equipment Manual

Control Units
3.1 Control Unit CU320-2 PN (PROFINET)
Note
Cable cross section
The measuring terminals are only suitable for conductor cross-sections of 0.2 mm
1 mm
Note
Use of the measuring socket
The measuring socket supports commissioning and diagnostic functions. It must not be
connected for normal operation.
3.1.2.10

Buttons

RESET button
Pressing the RESET button restarts the device, just the same as after connecting the
electronics power supply (cold restart).
DIAG button
The DIAG pushbutton is reserved for service functions.
3.1.2.11

Slot for memory card

Figure 3-4
22
.
2
Slot for memory card
up to
2
Supplementary component descriptions
Manual, 06/2019