Rinsing And Protecting From Frost - Tecnoma VECTIS 800e Adjustments, Use And Maintenance

– USING THE MACHINE –
5.8.13.1 Preparation
1. Put approx. 100 litres of clean water in the main tank.
2. Add the right cleaner for your equipment (carefully follow the instructions from the cleaning
product manufacturer).
5.8.13.2 Rinsing the tank using the LAV'TON washers
► Refer to the paragraph "Rinsing the spray mixture tank using the LAV'TON washers" (function 3
in the table label).
5.8.13.3 Rinsing the boom circuit
► Refer to the paragraph "Spraying" (function 2 in the table label).
5.8.13.4 Draining the spray mixture tank
Ö By spraying in the field
 Refer to the paragraph "
Ö Draining into a retention tank
1. Remove the (yellow) safety plug.
2. Pull on the remote draining cord to drain the tank
(read the paragraph on draining the spray mixture tank).
REMARK
To better drain the spray mixture tank, switch off tank bottom agitation.
3. Remove and clean the filters and nozzles separately in a solution of the cleaning product.
4. Cleaning the outside of the machine
 Refer to the paragraph "Cleaning the outside of the sprayer".

5.8.14 - RINSING AND PROTECTING FROM FROST

REMARK
Protecting from frost with nitrogen invalidates the warranty!
1. Perform a rinse and complete clean of the sprayer.
► Read the previous paragraph.
2. Completely drain the machine.
3. Fill 50 litres of water and 20 litres of antifreeze in the rinsing tank.
4. Transfer the mixture to the main tank using the LAV'TON washers.
► Refer to the paragraph "Rinsing the spray mixture tank using the LAV'TON washers" (function 3
in the table label).
5. Run the agitation for a few minutes.
► Refer to the paragraph "Agitation in the mixture tank".
Spraying"
(function 2 in the table label).
MAy-2015
Fig.33
Draining the tank
Remote emptying
79